If you just bought a home theater system or a couple of speakers, you will need some tips on properly configuring it in the event that you don’t desire to hire an installer. You may think you’re technically savvy and that installing your brand-new home theatre system would have been a snap. I will give some recommendations that will allow you to avoid some commonly made mistakes.
After unpacking your brand-new home theatre system, you will most likely find one central component in addition to 5 or 7 speakers 音響店推薦. The central component is going to provide the audio for all your speakers which you are going to set up. This central component can also be referred to as surround sound receiver or amplifier. It’s the central hub of your home theater system.
Be sure that you put this receiver in a location that is fairly centrally located to minimize the total amount of speaker wire that you’ll require to run. You don’t necessarily need to put the receiver right alongside your TV. Just make certain it is in a dry and safe place. Also, be sure that it is simple to reach the receiver from your own TV or DVD/Blue-ray player as you will have to connect these.
Connecting the receiver to power and to your TV or DVD is fairly straightforward. Most modern TVs have a visual output which connects right to your receiver via a fiberoptical cable. This cable may possibly not be added to one’s body but it can be obtained at any electronics store. However, establishing your speakers may be a bit more tricky.
When you yourself have wireless rear speakers you won’t need the maximum amount of speaker cable and the setup will soon be somewhat easier. To start with, measure how much speaker cable you will need. Ensure that you add some extra cable to take into consideration those bends and corners. Pick the gauge of the speaker cable depending on how much power you intend to drive your speakers with. The bigger the ability the thicker the speaker cable. Your subwoofer will most likely have an integrated amp and hook up to your receiver via RCA cable.
When connecting the speaker cable, be sure that you connect the cable with the right polarity. Each speaker has a color coded terminal, usually red and black. Pick a speaker cable that shows one strand in an alternative color than the other. Then connect the cable to all speakers the same way. Then, when connecting the speaker cable to your receiver, ensure that you connect the cable to each speaker terminal at the receiver in the same manner. This will keep carefully the sound planning to each speaker in the correct phase and optimize your sound experience.
Wireless rear speakers will typically incur an audio delay during transmission. This delay is also referred to as latency. Often the latency ranges between 1 and 20 ms. For optimum effect, it is most beneficial if all of the speakers have been in sync. When you yourself have a system that uses wireless rears and wired front speakers, i.e. you have a mixture of wireless and wired speakers, you should try to delay the audio planning to the wired speakers by the latency of the wireless speakers.
Seek advice from the manufacturer if your surround receiver may be set to delay the audio of specific channels. If you’re using wireless rears, you wish to set the front-speaker and side-speaker channels to delay the audio. Home theater systems of not created for wireless rear speakers may not need this capability. In this instance you might want to choose a wireless speaker kit that has very low latency, ideally significantly less than 1 ms. This will keep all your speakers in perfect sync.